KitchenAid ice maker not working? ٰI also faced the same problem when I used my KitchenAid Ice Maker for a long time. I was relieved to know that I was not only the one who faced the same problem.
Many people along with me faced the same. I searched for some fixes and got my ice maker working again.
It can be caused by many things, and often the solutions are simple and quick! Keep reading to learn more about common causes of your KitchenAid ice maker not working and how to fix it quickly and affordably!
The water inlet valve
Check to see if there is a green water intake valve on your refrigerator. This part can become clogged over time and when that happens, it can cause problems with your ice maker and water dispenser.
Fortunately, you should be able to find replacement valves online or at any local hardware store. Once you have one in hand, all you need to do is remove your old one and replace it with a new one.
You’ll probably want to turn off your water supply before doing so. Afterward, test out your ice maker and see if it works properly again. If not, continue reading for more possible solutions.
The water level controller
Turn off your refrigerator and unplug it. Inspect both wires coming from it. The one connected to ‘Common’ needs to be connected to the ground. You can use a wire nut to connect them together or a twist-on connector with 3 connections (2 yellow/black, 1 green/white).
You can also use a length of wire with alligator clips. The controller is right below where you would place it so either way is simple. Once you have grounded the white wire, plug your fridge back in and turn it on.
If you get an error message about an air pocket then simply repeat these steps until it goes away (it should go away in 2-3 cycles). If that doesn’t work then your controller has gone bad.
The ice maker control board
You can access your ice maker by removing an inspection panel on either side of your refrigerator or freezer. These panels are held in place with metal screws. Turn off your freezer, unplug it and make sure it is not running on ice built up in its icemaker tray.
If you have a manual or electronic icemaker, remove any large pieces of ice and pull out any remaining ice before proceeding. Check that all wires are still connected to both ends of each component.
Most new models only need one wire attached for them to function properly, so if you see multiple connections, use your multimeter to check for continuity between wires at each connection point before reattaching anything.
Never work on live appliances unless they are turned off and unplugged!
The wiring harness inside the refrigerator
First, check that your ice maker is getting power. Go to your breaker box and look for a switch labeled Kitchen Aid Refrigerator, Ice Maker, or similar.
Flip it off, wait a few minutes and then flip it back on again. If you don’t see lights inside your refrigerator when you do that, there’s something wrong with your wiring harness in which case call in an electrician. (Turning off power could cause damage.)
Water supply hoses
KitchenAid ice makers use a pair of hoses to draw water from your refrigerator’s water dispenser and deliver it to their ice maker.
It’s a simple system, but if one of those hoses has a kink or hole in it, ice production stops cold.
The fix is easy; all you need is a pair of pliers and either a replacement hose or some Teflon tape. How you proceed depends on which hose is at fault, so read on for instructions.
Water filter replacement (optional)
In many refrigerator models, a water filter is installed inside or near your ice maker. Replacing it could be as simple as opening up your fridge and pulling out an old filter and replacing it with a new one.
(Or if you’re really struggling with how to fix the KitchenAid ice maker not working, you can just do without.) If you don’t see a water filter in yours, don’t fret—it’s probably under-the-counter.
If that’s the case, look for a red or green tag on your fridge (depending on which brand of filter it uses). To replace it all you have to do is screw off the old filter and screw on a new one—very easy!
Also read: Euhomy Ice Maker Not Making Ice Issue Solved
Conclusion
For a variety of reasons, ice makers are no longer considered an essential appliance. You might have solved the problem of KitchenAid Ice Maker Not Working through this article. In today’s smaller kitchens, they may not even be possible to add.
But regardless of your kitchen’s size or layout, an ice maker can still be a very convenient feature to have if you enjoy fresh ice on a regular basis.
The best part about adding an ice maker is that it can save you money in the long run – after all, how much would you pay for four bags of ice at your local convenience store?
Next time your refrigerator makes a funny noise, take a minute to do some troubleshooting. You just might solve your problem and end up with cool, clear ice all at once!
