Harbor Breeze ceiling fans are simple to use and offer high-quality and unique design features at affordable prices. Whether you choose a Harbor Breeze ceiling fan with lights or one without, you’ll find these fans to be among the most reliable on the market today.
However, there are times when a Harbor Breeze ceiling fan just won’t work despite there being any visible signs of damage or malfunction.
This can often be fixed by following this short guide that will show you how to fix Harbor Breeze ceiling fan problems so your family can enjoy cool air once again!
Remove The Blade
To remove a ceiling fan blade, first, use a screwdriver to loosen both screws that secure it to its mount. It’s best to start with the blade closest to you, as it may be easier to reach.
Once both screws are loose, hold one hand under or on top of each blade as you twist it off using your other hand. This prevents splinters or tears from forming in your fan’s finish.
If you’re replacing an existing blade with a new one, do not remove any hardware from it before installing your new blade!
Check for loose connections with a flashlight
Most Harbor Breeze ceiling fans have a light kit that connects to the fan with a series of wires and connectors. If you notice any loose connections, wiggle them slightly to see if they come back into place.
If that doesn’t work, your connections may need replacing. But only an electrician can do that safely and legally. Note: Always turn off your ceiling fan before trying to make repairs.
While you’re at it, you should also double-check all electrical wiring in your house or business for any other signs of damage or wear-and-tear. Worn wire insulation might be hiding smaller problems that could put you in danger down the road.
Replace the receiver board
If you determined that a new receiver board is needed, proceed to the next step. Be sure to turn off your ceiling fan/light circuit breaker. Disconnect all wires from your existing receiver board before removing them from its mounting bracket.
Remove two screws holding each wire terminal block onto your old receiver board, unplug them, and remove them with their attached wires. Unscrew each of the four screws on your old receiver board and remove it. Set aside.
Replace the remote control
If you are able to turn on your fan but not control it, then there is a problem with your remote. The remote may need to be replaced or it may need new batteries. Check to see if you can locate new batteries in your home and replace them.
This should fix your issue of the Harbor Breeze ceiling fan light not working but the ceiling fan works fine. If that does not work, then you will have to purchase a new remote control for your fan as these cannot be fixed easily or cheaply.
Most likely, you will have to purchase one that matches your current model number as well. So make sure you get all information from where you purchased it. So that you can purchase another one like it so that it can match perfectly with no problems whatsoever!
Replace the circuit board
Switch out your ceiling fan’s circuit board. Since it’s an electrical issue, you’ll want to leave this one to a pro. Find an electrician to perform these repairs.
After disconnecting power to both components, he or she will replace your old circuit board with a new one and make sure everything is working again properly.
It may sound expensive, but it should only take around two hours and cost around $200 on average (prices will vary depending on where you live).
Also read: Ceiling Fan Stopped Working Suddenly But Lights Still Works Fixed
If your Harbor Breeze ceiling fan light works but not the fan, it’s likely because of a faulty connection between your wall switch and motor.
If that’s happening to you, there are two solutions you can try before calling a professional: (1) Buy an inexpensive 3-way ceiling fan switch and replace it with your current one.
Or (2) Buy a dual-control remote for about $20 at any hardware store. Either way, will solve your problem so be sure to share with others who might be having similar issues!