Intex Air Mattress Pump Keeps Shutting Off-An Ultimate Solution

Intex Technologies is an Indian transnational electronics manufacturing services company that manufactures smartphones, consumer electronics, and other accessories. It also provides consumer electronic products similar as MP3 players, DVD players and speakers. It was innovated in 1996 and is headquartered in New Delhi, India.

Intex Air Mattress Pump Keeps Shutting Off-An Ultimate Solution

The Intex Air Mattress Pump Keeps Shutting Off can be an essential accessory if you own an Intex air mattress or another brand.

The problem might be that the pump will keep shutting off, so here are some things you can do to fix the problem and get back to peaceful nights in your air bed again. If the instructions don’t work, your pump might have to be replaced entirely.

I also faced the same problem because it is an important household accessory. I consulted an expert and tried the following fixes.

Power Cord

The first thing you should check if your Intex air mattress pump keeps shutting off is the power cord. If it’s damaged, it may be causing the pump to overheat and shut down.

Solution

To replace the power cord, you’ll need a screwdriver and a new power cord. Start by unscrewing the two screws that hold the cover on the back of the pump. Then, unplug the old power cord and remove it from the housing.

Next, thread the new power cord through the housing and plug it in. Finally, screw the cover back on and turn on the pump to test it.

Intex Air Mattress Pump Keeps Shutting Off

Solenoid Valve

The solenoid valve is a black box located on the side of the pump. If this pump if not working well it can cause problem to the device. However, this problem is major or minor.

Solution

To fix this, you’ll need to unscrew the four screws on the top and bottom of the valve and then remove the cover. Inside, you’ll find a spring and a diaphragm. You can find replacement parts online or at a hardware store. Once you have the new parts, simply reverse the process to reassemble the valve.

Cartridge Valve

If your Intex air mattress pump keeps shutting off, it can be the cartridge valve. First open the device and analyze the valve. If you find any problem fix it. You can also replace it simply and its the best solution.

Solution

This is a simple repair that anyone can do at home.

1. Remove the old cartridge valve by unscrewing it from the base of the pump.
2. Insert the new cartridge valve into the base of the pump.
3. Screw the new valve in place and hand-tighten it until it’s snug.
4. Reconnect the hoses to the new valve and make sure they’re secure.
5. Turn on the power to the pump and test it out by inflating a mattress or pool float.
6. If everything is working properly, screw on the cap to seal up the pump.

The Switch

You also need to analyze the switch. If the switch is notworking well fix it or, you’ll need a replacement switch, which you can find at an electronics store or online.

Solution

To replace the switch, first, locate it on the circuit board. It’s usually a small, black component with two wires leading to it.

Carefully disconnect the wires from the old switch and then solder the new switch in its place. Once the new switch is in place, reconnect the wires and test out your air mattress pump to see if it works properly.

Over Heat

Sometimes air mattress pumps shut off due to over heat. Excessive deflation can cause over heat in the system, that is the one possible reason due to which your pump keeps shutting off. In this case, the power will be cut off and It will also turn the power light on.

Solution 

Try to use the pump in less than 30 minutes. Excessive usage can cause over heat in the pump.

FAQ’s

Is an Intex air mattress good for everyday use?

While it may not be the overall stylish air mattress, it’s comfortable enough to sleep on and a great pick for everyday use. The integrated, plug- in pump is not as presto to inflate as others but it’s aplenty important and the bed ranks among the firmest blow- up mattresses that we tested.

How often should you run the pump on an Intex pool?

Every pool should cycle through all of its water at least once a day, so most pool possessors will want to run their pumps for at least 4- 8 hours daily. But you do not have to run those 4- 8 hours each at formerly so you can resolve the pump time over at different corridor of the day to ease your energy budget.

 

Also go through: Intex Air Mattress Pump Not Working Ultimate Guide

Conclusion

If your Intex air mattress pump keeps shutting off, there are a few things you can do to fix the problem. First, check to make sure the power cord is plugged in securely.

Next, check the battery to see if it needs to be replaced. Finally, if neither of those solutions works, you may need to replace the pump.

I'm a Professional Content Writer on howtofinders.com and willing to write Articles on Technology-based Items. Writing basically is not my job but I consider it as my hobby and passion. I have been working as a Content writer for quite some time.
I'm a Professional Content Writer on howtofinders.com and willing to write Articles on Technology-based Items. Writing basically is not my job but I consider it as my hobby and passion. I have been working as a Content writer for quite some time.

Leave a Comment