How To Reset Honeywell Air Purifier If Fan Not Working? Before you begin resetting your air purifier, check to see if there’s anything obstructing the fan so that it cannot rotate and draw in the fresh air.
Also make sure that the device itself has power—the fan should not be moving at all if it’s not plugged in or if its power cord has been severed or if the outlet or fuse box has blown out due to some malfunction of the device itself.
Turn Off Power
One way to stop humming, clicking, or beeping fan from working is to turn off the power.
If your air purifier comes with a control switch and doesn’t automatically shut off when it senses no movement for 10 minutes, you should use that switch to turn off the power immediately.
Because without power, there will be no current moving through its coils and its motor won’t make any noise.
However, if your air purifier runs using a remote control rather than a wall switch—some models of Trane air purifiers have remotes—then you might find it easier to reset instead of turning off the power.
You can often reset an electronic device by pressing off three times in rapid succession.
Unplug From The Wall
Sometimes your fan may not be working due to a blown fuse.
This is actually very common with plug-in fans because they run on low voltage and don’t have much protection against power surges, short circuits, etc.
You can easily reset your fuse by unplugging it from the wall outlet and waiting 10 minutes before plugging back in.
The fuse should reset itself during that time period.
Press And Hold The Clear/Off Button
In order to reset your air purifier, you must first be sure that it is unplugged. Once you’ve done that, press and hold down on the Clear/Off button.
This is located right in front of where you insert filters.
It should take about 20 seconds for your unit to completely shut off.
Once it has turned off, release your finger from the Clear/Off button and wait until it turns back on by itself, at which point you may proceed to use your machine again.
Wait At Least 10 Seconds
In rare cases, resetting your unit may not work. It could be that there is a malfunction somewhere in your fan’s circuitry.
What you can do at that point is hold down your purifier’s ON/OFF button for at least 10 seconds and then release it to see if it will kick back on.
If it doesn’t come back on immediately after you let go of its ON/OFF button, give it another 20 seconds before trying again.
In most cases, purifiers with faulty fans will turn on again after a second reset attempt or two minutes.
Reconnect Power Cord, Then Check To See That The Unit Has Powered On
First, make sure that you have properly reconnected your air purifier’s power cord.
You should connect it to a grounded wall outlet, and then check that it is plugged into a functioning outlet.
Second, make sure that your unit has powered on by pressing it’s on/off button or remote control.
Also, ensure that you have waited at least 30 seconds before resuming action to allow your purifier time to boot up fully and resume normal operation.
Lastly, try switching between fan speeds (low speed to high speed) using either your unit’s dial or remote control; sometimes slow fans can skip steps if they are turned on too quickly.
Also read: Fix Homedics Humidifier Not Working
Conclusion
Honeywell air purifiers are convenient and come with all kinds of handy features.
Unfortunately, if your fan isn’t working, you may need to reset it. There are a few different ways to do so depending on your model. We hope you find these tips helpful!
If you have any questions at all or need more information, please feel free to contact the customer support of the company.
You can also ask me your queries in the comments section. We’d be happy to help in any way we can!
